top of page

Dyno Developments

Based near London in the United Kingdom the company has many years experience in the Dynamometer, Tuning, Electronics and Software industry.

​

World known for the abilty to run small and large Horsepower vehicles on the same equipment, the Dynamometer control systems are the fastest and most stable in the Industry with very fine load control and update speeds of 50,000 times a second.

​

Our company philosophy is Excellence in Power, Measurment and Load Control

Excellent load control and accuracy allows a tuner to know if his hard efforts are actually making an improvement.

​

High levels of accuracy allow the customer to be sure any power gains are legitimate and can be reproduced again and again.

Dyno Developments

The dynamometer (DYNO) comes fully equipped. You only need to connect power and place it above or below ground and start using it from day 1.

 

The dyno has eddy-brake load control. It can run from as low as 2 HP to 1,200 HP (2WD) and 2,400 HP (4WD).

​

The load control can help you map the engine at various points otherwise impossible on non braked dyno.

DD2wd_iso.jpg
eddy brake.jpg

Eddy Brake

The Brake equipped with each dyno can hold up to 1,200 HP peak, and 600 Nm constant load.

Dyno software

Dyno Development software is one of the most intuitive and easy to use.

​

All of the data you need is there in one screen. No need to switch the screen to hold or do power runs.

​

Air/ Fuel ratio, Boost, and 4 other analog channels are logged in real time.

​

The controller is able to receive EGT inputs, and CAN inputs

program-info.jpg
Remote-info.jpg

Remote Controller

The remote is one of the unique feature that Dyno Development has.

​

From setting up the RPM sync, Hold km/h, turn fan on/off, do a power run, to move the bed length. All is there in your hands.

Dyno Developments 2WD

The best selling model, 2WD. 

​

Specifications :

  • Max 1,200 HP

  • Load control

  • 220 V

  • A/F, Boost logging

  • 4 additional analog channels

​

Package :

  • 2 set of ramps (front and rear)

  • Powerful 6,000 cfm fan

  • Wheel blocks

  • 4 set of 5 tons straps

  • 2 High HP traction bar

  • A/F meter

  • Boost gauge

2wd-info.jpg
4wd-info.jpg

Dyno Developments 4WD

The most complete model.

​

Specifications :

  • Max 2,400 HP (4WD)

  • Load control

  • 380 V

  • A/F, Boost logging

  • 4 additional analog channels

​

Package :

  • 1 set of ramps (front)

  • Powerful 6,000 cfm fan

  • Wheel blocks

  • Adjustable bed

  • 4 set of 5 tons straps

  • 2 High HP traction bar

  • A/F meter

  • Boost gauge

4WD sync link system is optional.

bottom of page